Command Reference Guide

308 ● speed 3Com Router 5000 Family and Router 6000 Family
Command Reference
speed
Purpose Use the speed command to configure the rate of the port.
Use the undo speed command to restore the default port rate, that is,
negotiation.
Syntax speed { 10 | 100 | negotiation }
undo speed
Parameters 10
Port rate is 10 Mbps.
100
Port rate is 100 Mbps.
negotiation
Port rate is to be negotiated.
Example Set port rate on port Ethernet 1/0/1 to 100 Mbps.
[3Com -Ethernet1/0/1] speed 100
View This command can be used in the following views:
■ Ethernet Port view
Description When setting the port to auto-negotiation mode, you must ensure that the
connected port is operating in the same mode. If otherwise, you must set both ports
to operate in the same mode manually.
Related Command duplex