Command Reference Guide

300 ● shdsl mode 3Com Router 5000 Family and Router 6000 Family
Command Reference
shdsl mode
Purpose Use the shdsl mode command to set the operating mode of the G.SHDSL interface.
Use the undo shdsl mode command to restore the default.
Syntax shdsl mode { co | cpe }
undo shdsl mode
Parameters co
Sets to the central office (CO) mode.
cpe
Sets to the customer premises equipment (CPE) mode.
Default By default, the G.SHDSL interface is operating in CPE mode.
Example Set the operating mode of interface ATM 1/0/0 to CO mode.
[3Com -Atm1/0/0] shdsl mode co
View This command can be used in the following views:
■ ATM (G.SHDSL) Interface view
Description On a back-to-back connection, you must set one end to CO mode and the other end
to CPE mode.