Command Reference Guide

268 ● multiplex mode 3Com Router 5000 Family and Router 6000 Family
Command Reference
multiplex mode
Purpose Use the multiplex mode command to set AUG multiplexing mode.
Use the undo multiplex mode command to restore the default setting, au-4.
Syntax multiplex mode { au-4 | au-3 }
undo multiplex mode
Parameters au-4
Gets AUG through AU-4.
au-3
Gets AUG through AU-3.
Example In SDH mode, multiplex AUG to AU-3.
<3Com > system-view
[3Com ] controller cpos 1/0/0
[3Com -Cpos1/0/0] frame-format sdh
[3Com -Cpos1/0/0] multiplex mode au-3
View This command can be used in the following views:
■ CPOS Interface view
Description SDH provides two payload map/multiplex solutions: ANSI and ETSI.
The multiplex schemes of ANSI and ETSI are AU-3 and AU-4 respectively.
When the CPOS interface is operating in SDH mode, you can choose to multiplex
AUG to AU-4 or AU-3 by using the
multiplex mode command. When the CPOS
interface operates in SONET mode, AUG can only be multiplexed to AU-3 and the
multiplex mode command is invalid in this case.
Related Command frame-format