Command Reference Guide

262 ● modem adapt no-waiting-connect 3Com Router 5000 Family and Router 6000 Family
Command Reference
modem adapt no-waiting-connect
Purpose Use the modem adapt no-waiting-connect command to set the
asynchronous serial interface Modem to switch from IDLE to ACTIVE without waiting
for receiving the signal CONNECT (a signal used for a physical modem to negotiation
rate) after it receives CD_UP (a lower layer detects carrier signal).
Use the undo modem adapt no-waiting-connect command to set the
asynchronous serial interface Modem to switch from IDLE to ACTIVE until it receives
the signal CONNECT after it receives CD_UP (a lower layer detects carrier signal).
Syntax modem adapt no-waiting-connect
undo modem adapt no-waiting-connect
Parameters None
Default By default, the asynchronous serial interface Modem switches from IDLE to ACTIVE
until it receives the signal CONNECT after it receives CD_UP (a lower layer detects
carrier signal).
Example Set the asynchronous serial interface Modem to switch from IDLE to ACTIVE without
waiting for the CONNECT signal after it receives CD_UP (a lower layer detects carrier
signal).
[Router-ui-aux0] modem adapt no-waiting-connect
View This command can be used in the following views:
■ User Interface view