Command Reference Guide

234 ● invert transmit-clock 3Com Router 5000 Family and Router 6000 Family
Command Reference
invert transmit-clock
Purpose Use the invert transmit-clock command to enable the inverting of the
transmit-clock signal of the synchronous serial interface at the DTE side.
Use the undo invert transmit-clock command to disable inverting the
signal.
Syntax invert transmit-clock
undo invert transmit-clock
Parameters None
Default By default, transmit-clock signal inversion is disabled on the synchronous serial
interface at DTE side.
Example Invert the transmit-clock of the synchronous serial interface at DTE side.
[3Com -Serial0/0/0] invert transmit-clock
View This command can be used in the following views:
■ Serial Interface view
Description In some special cases, for eliminating the half-period delay of the clock on the line,
you may make the configuration to make the system invert the transmit-clock signal
of the synchronous serial interface at the DTE side. This command can take effect only
on some specific DCE devices. Clock inversion is unnecessary to general applications.
Related Commands ■ physical-mode
■ invert receive-clock
■ clock (Serial Interface)