Command Reference Guide

220 ● interface 3Com Router 5000 Family and Router 6000 Family
Command Reference
interface
Purpose Use the interface command to enter the specified interface view or create a
logical interface or subinterface.
Use the undo interface command to delete a specified logical interface or
subinterface.
Syntax interface type number [ .sub-number ]
undo interface type number [ .sub-number ]
Parameters type
Interface type. Table 1 lists the interfaces that VRP
supports so far.
number
Interface number. VRP numbers the interfaces
separately by interface type, with the numbers of each
type of interfaces beginning at 0 or 1.
sub-number
Subinterface number, which is separated from the
main interface number by a dot (.).
Example Enter the Ethernet interface view in system view.
[3Com ]interface ethernet 0/0/0
[3Com -Ethernet0/0/0]
Switch from Ethernet0/0/0 view to the view of the subinterface Serial0/0/0.1.
[3Com -Ethernet0/0/0] interface serial0/0/0.1
[3Com -Serial0/0/0.1]
View This command can be used in the following views:
■ System view
Description
Table 1 Interfaces supported by VRP
Interface Description Attribute
ATM ATM interface Physical interface
AUX AUX interface Physical interface
AnalogModem Analog modem interface Physical interface
Async Asynchronous serial interface Physical interface
Bri ISDN BRI interface Physical interface
Bridge-Template Bridge-group virtual interface Logical interface
controller e1 E1 interface Physical interface
controller t1 T1 interface Physical interface
controller e3 E3 interface Physical interface