Command Reference Guide

190 ● flow control 3Com Router 5000 Family and Router 6000 Family
Command Reference
flow control
Purpose Use the flow-control command to enable flow control on the Ethernet interface,
which is useful only when the peer end also supports flow control.
Use the undo flow-control command to restore the default.
Syntax flow-control
undo flow-control
Parameters None
Default By default, flow control is disabled.
Example Enable flow control on GE interface 0/0/0.
<3Com > system-view
[3Com ] interface gigabitethernet 0/0/0
[3Com -GigabitEthernet0/0/0] flow-control negotiation
View This command can be used in the following views:
■ Ethernet Interface view
Description When using this command, keep the configuration the same as that of the peer end.