Command Reference Guide

188 ● ft1 timeslot-list 3Com Router 5000 Family and Router 6000 Family
Command Reference
ft1 timeslot-list
Purpose Use the ft1 timeslot-list command to bundle timeslots on the T1-F interface.
Use the undo ft1 timeslot-list command to restore the default.
Syntax ft1 timeslot-list range [ speed { 56k | 64k } ]
undo ft1 timeslot-list
Parameters range
Timeslots participating in the bundling. Valid values are
1 to 24. When specifying timeslots to be bundled, you
can configure any of the following:
■ one timeslot by specifying its number
■ a timeslot range by specifying a range in the form
number1-number2
■ discrete timeslots by specifying number1,
number2-number3.
speed { 56k | 64k }
Time slot bundling speed in kbps. If 56k applies,
timeslots are bundled into an N x 56 kbps bundle. If
64k applies, timeslots are bundled into an N X 64 kbps
bundle.
Default By default, all the timeslots on the T1-F interface are bundled to form a 1536 kbps
interface.
Example Bind the timeslots 1, 2, 5, 10 through 15, and 18 on the T1-F interface.
[Router-Serial0/0/0] ft1 timeslot-list 1,2,5,10-15,18
View This command can be used in the following views:
■ T1-F Interface view
Description Time slot bundling results in interface rate change. For example, after you bundle
timeslots 1 through 10 on the interface, the interface rate becomes 10 x 64 kbps or
10 x 56 kbps.
When binding T1-F interface with Virtual-template, if you want to use the ft1
timeslot-list command to modify T1-F interface time-slot bundling, shutdown
the corresponding T1-F interface and execute the
ft1 timeslot-list command.
Note that you should perform the above modification on the two T1-F interfaces on
both end of the link and then execute the undo shutdown command to T1-F
interface; otherwise, when you execute the
display interface