Command Reference Guide

170 ● fe1 detect-ais (E1-F interface) 3Com Router 5000 Family and Router 6000 Family
Command Reference
fe1 detect-ais (E1-F interface)
Purpose Use the fe1 detect-ais command to enable alarm indication signal (AIS) detect
on the E1-F interface.
Use the undo detect-ais command to disable AIS detect on the E1-F interface.
Syntax fe1 detect-ais
undo fe1 detect-ais
Parameters None
Default By default, AIS detect is enabled on the E1-F interface.
Example Disable AIS detect on E1-F interface serial 3/0/0.
[3Com -serial 3/0/0] undo fe1 detect-ais
View This command can be used in the following views:
■ E1-F Interface view
Description Before enabling or disabling AIS detect for an E1-F interface, you must configure the
interface to operate in unframed mode with the
fe1 unframed command.