Command Reference Guide

3Com Router 5000 Family and Router 6000 Family eliminate-pulse ● 163
Command Reference
eliminate-pulse
Purpose Use the eliminate-pulse command to eliminate the pulses with a width less than
3.472us, increasing signal reliability. This is useful when the line is seriously interfered.
Use the undo eliminate-pulse command to restore the default, eliminating the
pulses with a width less than 1.472 us.
Syntax eliminate-pulse
undo eliminate-pulse
Parameters None
Example Eliminate the pulses with a width less than 3.472 us on interface Async1/0/0.
[Router-Async1/0/0] eliminate-pulse
View This command can be used in the following views:
■ Asynchronous Serial Interface view
Description You can use this command only when the baud rate of the interface is less than
115,200 bps. After you configure this command, the baud rate of the interface
cannot be set to 115,200 bps or greater.
This command is restricted to the 8ASE and 16ASE interface cards and modules.