Command Reference Guide

162 ● e1 unframed 3Com Router 5000 Family and Router 6000 Family
Command Reference
e1 unframed
Purpose Use the e1 unframed command to set an E1 channel on the CPOS interface to
unframed mode or E1 mode.
Use the undo e1 unframed command to restore the default setting, channelized
mode.
Syntax e1 e1-number unframed
undo e1 e1-number unframed
Parameters e1-number
Number of an E1 channel on the CPOS interface. Valid
values are 1 to 63.
Example Set E1 channel 3 on the CPOS interface 1/0/0 to operate in unframed mode.
<3Com > system-view
[3Com ] controller cpos 1/0/0
[3Com -Cpos 1/0/0] e1 3 unframed
View This command can be used in the following views:
■ CPOS Interface view
Description When the E1 channel is set to work in unframed mode, it does not include frame
control information and does not allow timeslot division or bundling.
E1 commands are available with the CPOS(E) interface module but not with the
CPOS(T) interface module.