Command Reference Guide

3Com Router 5000 Family and Router 6000 Family e1 channel-set ● 151
Command Reference
e1 channel-set
Purpose Use the e1 channel-set command to bundle multiple timeslots on an E1 channel
into one channel set.
Use the undo e1 channel-set command to remove the bundle.
Syntax e1 e1-number channel-set set-number timeslot-list range
undo e1 e1-number channel-set range
Parameters e1-number
Number of an E1 channel on the CPOS interface. Valid
values are 1 to 63.
set-number
Channel set number. Valid values are 0 to 30.
range
Timeslots assigned to the channel set. Valid values are
1 to 31.
Example Bundle timeslots on E1 channel 63.
<3Com > system-view
[3Com ] controller cpos 1/0/0
[3Com -Cpos1/0/0] e1 63 channel-set 1 timeslot-list 1-31
Enter the view of the serial interface formed by the timeslot bundle.
[3Com -Cpos1/0/0] quit
[3Com ] interface serial 1/0/0/63:1
[3Com -Serial1/0/0/63:1]
View information about the serial interface formed by a timeslot bundle.
<3Com > display interface serial 1/0/0/63:1
View This command can be used in the following views:
■ CPOS Interface view
Description When the E1 channel is channelized, its timeslot 0 is used for synchronization and the
other 31 timeslots can be bundled to form one or multiple serial interfaces.
Note:
■ To guarantee the processing capacity of the system, you can have only up to 256
virtual serial interfaces on one CPOS physical interface.
■ E1 commands are available with the CPOS(E) interface module but not with the
CPOS(T) interface module.