Command Reference Guide

140 ● display virtual-access 3Com Router 5000 Family and Router 6000 Family
Command Reference
display virtual-access
Purpose Use the display virtual-access command to view state information about
the specified or all virtual access interfaces.
Syntax display virtual-access { dialer [ number ] | vt [ vt-number ] | user
user-name | peer peer-address | va-number }*
Parameters dialer number
Dialer interface number.
vt-number
Number of the virtual template to which the virtual
access interface is assigned.
user-name
Login username of virtual access interface.
peer-address
Peer address of the virtual access interface.
va-number
Sequence number of the virtual access interface.
Example Display state information about all virtual access interfaces.
<3Com > display virtual-access vt
Virtual-Template1:0 current state :UP
Line protocol current state :UP
Description : Virtual-Template1:0 Interface
The Maximum Transmit Unit is 1500
Link layer protocol is PPP
LCP opened, MP opened, IPCP opened, OSICP opened
Physical is MP, baudrate: 64000
Output queue : (Urgent queue : Size/Length/Discards) 0/50/0
Output queue : (Protocol queue : Size/Length/Discards) 0/500/0
Output queue : (FIFO queuing : Size/Length/Discards) 0/75/0
Last 300 seconds input: 0 bytes/sec 0 packets/sec
Last 300 seconds output: 0 bytes/sec 0 packets/sec
4 packets input, 50 bytes, 0 drops
4 packets output, 50 bytes, 0 drops
View This command can be used in the following views:
■ Any view
Description For VT and dialer interfaces used in MP, PPPoE, and PPPoA, the system may create
virtual access interfaces depending on link state. Thus, to check their link state, you
must use the display virtual-access command.