Command Reference Guide

136 ● display status interface 3Com Router 5000 Family and Router 6000 Family
Command Reference
display status interface
Purpose Use the display status interface command to display the state of the
specified interface.
Syntax display status interface interface-type interface-number
Parameters interface-type
interface-number
Specifies an interface by its type and number.
Example Display the state of Ethernet interface 0/0/0.
[Router] display status interface ethernet 0/0/0
transmit information
call times: 1
callok times: 1
done times: 1
delay times: 0
destroy time: 0
receive information
done times: 0
get ok mbufs: 0
make mbuf fails: 0
no buffer times: 0
Rx disable times: 0
Rx enable times: 1
software statistical information :
pMsg address: 0x04a6b9a4
pci Base: 0x80000000
slot/port isr: 0x0/0x64
EthType Flag: 0x0000ffff
RxBD Base: 0x00000000
TxBD Base: 0x00000000
TxAuxBD Base: 0x04a6ca68
Intr Req times: 0
Intr Done times: 0
Intr Rnr times = 0
Max Tx BDs: 64
Max Rx BDs: 64
bd_tptr: 1
bd_cptr: 0
bd_rptr: 0
RPTR: 63
FreeBDs: 63
Hardware information of receive:
Input packets: 0
Broadcast packets: 0
Multicast packets: 0
Align error packets: 0
CRC errors packets: 0
Symb errors packets: 0
Sequence err packets: 0