Command Reference Guide

128 ● display interface loopback 3Com Router 5000 Family and Router 6000 Family
Command Reference
display interface loopback
Purpose Use the display interface loopback command to view state about the
specified or all created loopback interfaces.
Syntax display interface loopback [ number ]
Parameters number
Number of loopback interface, which must have been
created. If no loopback interface is specified, state
about all created loopback interfaces is displayed.
Example View state about the specified loopback interface.
<3Com > display interface loopback 0
LoopBack0 current state :UP
Line protocol current state :UP (spoofing)
Description : LoopBack0 Interface
The Maximum Transmit Unit is 1536
Internet Address is 1.1.1.1/32
Physical is Loopback
Last 300 seconds input: 0 bytes/sec 0 packets/sec
Last 300 seconds output: 0 bytes/sec 0 packets/sec
0 packets input, 0 bytes, 0 drops
0 packets output, 0 bytes, 0 drops
View This command can be used in the following views:
■ Any view
Related Command interface loopback