Command Reference Guide

3Com Router 5000 Family and Router 6000 Family display interface ima-group ● 125
Command Reference
display interface ima-group
Purpose Use the display interface ima-group command to view the configuration
and state information about the specified or all IMA group interfaces.
Syntax display interface ima-group [ slot/card/group-number ]
Parameters slot
Number of the slot for the ATM E1/T1 interface card.
card
Number of the ATM E1/T1 interface card.
group-number
IMA group number. Valid values are an integer from 1
to 8.
If no IMA group interface is specified, the
configuration of all existing IMA group interfaces and
their state information are displayed.
ExampleI Display the configuration and state information about IMA group interface 6/0/1.
[Router] display interface Ima-group 6/0/1
Ima-group6/0/1 current state :UP
Line protocol current state :UP
Description : Ima-group6/0/1 Interface
Total baudrate is 10808000 bps,the available baudrate is 10808000 bps
The Maximum Transmit Unit is 1500
Internet Address is 23.1.1.1/24
AAL enabled: AAL5, Maximum VCs: 128
Current VCs: 1 (1 on main interface)
Physical layer is ATM over IMA
IMA-clock: CTC, active-links-minimum: 1
Frame-length: 128, differential-delay-maximum: 25
symmetry: symmetrical configuration and operation
Ima-group state:
ImaGroupNeState:OPERATIONALImaGroupFeState:OPERATIONAL
ImaGroupNeFailureStatus:NO_FAILURE ImaGroupFeFailureStatus:
NO_FAILURE
Ima-Link Information:
Link Physical status Near End Tx Status
0 UP ACTIVE
1 UP ACTIVE
2 UP ACTIVE
3 UP ACTIVE
4 UP ACTIVE
5 UP ACTIVE
7 UP ACTIVE
Test Status: Disabled
Last clearing of counters: Never
Last 300 seconds input rate 0.08 bytes/sec, 0 bits/sec, 0.00
packets/sec