Command Reference Guide

120 ● display interface atm 3Com Router 5000 Family and Router 6000 Family
Command Reference
View This command can be used in the following views:
■ Any view
ATM over E1, Scramble
enabled, frame-format
crc4-adm
Physical layer: E1
Scrambling state: enabled or disabled
Frame format: CRC4 ADM or No-CRC4 ADM
code hdb3, clock
slave,Cable-length long,
loopback not set
Line coding type: HDB3 or AMI
Clock type: slave or master
Cable type: long or short
State of loopback setting
Cable type: 75 ohm
non-balanced
Cable type of the interface: 75-ohm unbalanced cable in this
example
Line Alarm: LOS LOF Line alarm
Line Error: 0 FERR, 0 LCV,
0 CERR, 0 FEBE
Statistics about errors
Last 0 seconds input rate
0.00 bytes/sec,
0.00 packets/sec
Input rate during a specified interval
Last 0 seconds output rate
0.00 bytes/sec,
0.00 packets/sec
Output rate during a specified interval
Input : 0 packets,
0 bytes, 0 buffers
0 errors, 0 crcs, 0 lens,
0 giants,
0 pads, 0 aborts, 0 timeouts
0 overflows, 0 overruns,
0 no buffer
Detailed statistics about input packets and their errors
Output: 0 packets,
0 bytes, 0 buffers
0 errors, 0 overflows,
0 underruns
Detailed statistics about output packets and their errors
Table 1 Description on the fields of the display interface atm command (continued)
Field Description