Command Reference Guide

3Com Router 5000 Family and Router 6000 Family display interface ● 111
Command Reference
View This command can be used in the following views:
■ Any view
Description If port type and port number are not specified when displaying the port information,
information on all the ports is displayed. If only port type is specified, information on
all the ports of this type is displayed. If both port type and port number are specified,
information on the specified port is displayed.
Flow-control is not supported Flow control setting on the port
Mac-aging time Aging time of MAC addresses
Broadcast MAX-ratio Broadcast storm suppression ratio on the port
Output flow-control is disabled, input
flow-control is disabled
Output flow control and input flow control are
disabled.
PVID Default VLAN ID of the port
Port link-type Link type of the port
Tagged VLAN ID Indicates the VLAN from which the packets must be
tagged.
Untagged VLAN ID Indicates the VLAN from which the packets are not to
be tagged.
Last 300 seconds output: 0 packets/sec 0
bytes/sec
Last 300 seconds input: 0 packets/sec 0
bytes/sec
The input and output rates as well as the input and
output packets in the last 300 seconds on the port
Input: 6 packets, 574 bytes, 0 buffers
0 b r o a d c a s t s , 0 m u l t i c a s t s , 0 p a u s e s
0errors,0runts,0giants
0 crc , 0 ali gn er rors, 0 o verru ns
0 dr ib b le s, 0 dr op s , 0 no bu ff er s
O u t p u t : 0 p a c k e t s , 0 b y t e s , 0 b u f f e r s
0 b r o a d c a s t s , 0 m u l t i c a s t s , 0 p a u s e s
0 e r r o r s , 0 u n d e r r u n s , 0 c o l l i s i o n s
0 deferred, 0 lost carriers
Statistics about input/output packets and errors on
the port
Table 1 Description on the fields of the display interface command (continued)
Field Description