Command Reference Guide

108 ● display interface 3Com Router 5000 Family and Router 6000 Family
Command Reference
display interface
Purpose Use the display interface command to view the current running state and
other information about an interface.
Syntax display interface type number [ .sub-number ]
Parameters type
Interface type, along with number identifies an
interface.
number
Interface number, along with type, identifies an
interface.
sub-number
Subinterface number.
Example View the running state and the relevant information about Serial 0/0/0.
[3Com ] display interface serial 0/0/0
Serial0/0/0 is up , line protocol is up
Description : Serial0/0/0 Interface
Virtualbaudrate is 300 bps
The Maximum Transmit Unit is 1500, The keepalive is 10(sec)
Internet protocol processing : disabled
Link layer protocol is PPP
LCP opened, MPLSCP stopped
FIFO queuing: (Outbound queue:Size/Length/Discards)
FIFO: 0/75/0
Physical layer is synchronous,Baudrate is 64000 bps
Interface is DCE, Cable type is V35
5 minutes input rate 0.56 bytes/sec, 0.04 packets/sec
5 minutes output rate 0.66 bytes/sec, 0.05 packets/sec
51 packets input, 640 bytes, 0 no buffers
55 packets output, 700 bytes, 0 no buffers
0 input errors, 0 CRC, 0 frame errors
0 overrunners, 0 aborted sequences, 0 input no buffers
DCD=UP DTR=UP DSR=UP RTS=UP CTS=UP
View This command can be used in the following views:
■ Any view
Description Executing this command displays the following information:
■ Physical and protocol state of the interface
■ Physical features of the interface (including operating mode, DTE/DCE, clock
selection, external cable, and so on.)
■ IP address of the interface