Command Reference Guide

102 ● display dsl version 3Com Router 5000 Family and Router 6000 Family
Command Reference
display dsl version
Purpose Use the display dsl version command to view the DSL version and the
available functionality.
Syntax display dsl version interface atm interface-number
Parameters interface-number
Interface number
Example Display the G.SHDSL version on interface ATM 3/0/0.
[3Com -Atm3/0/0] display dsl version interface atm 3/0/0
Dsl Line Type: G.SHDSL
ATM SAR Device: 0x823614f1
ATM SAR Revision: 0x02
Chipset Vendor: GSPN
Firmware Rel-Rev: R2.3.1-0
DSP Version: 1
PCB Version: 0.0
CPLD Version: 0.0
Driver Version: 2.0
Hardware Version: 1.0
ITU G991.2 ANNEX A: Supported
ITU G991.2 ANNEX B: Supported
View This command can be used in the following views:
■ Any view
Table 1 Description on the output of display dsl version interface atm
Field Description
DSL line Type Type of the user access line
ATM SAR Device Identifier of the SAR chip
ATM SAR Revision Revision identifier of the SAR chip
Chipset Vendor Identifier of the DSL chipset vendor
Firmware Rel-Rev Identifier and version of the firmware
DSP Version ––
PCB Version ––
CPLD Version Logic version
Driver Version Driver software version
Hardware Version ––
ITU G991.2 ANNEX A,
ITU G991.2 ANNEX B
Standards and the annexes supported by the interface