Command Reference Guide

3Com Router 5000 Family and Router 6000 Family display dsl status ● 99
Command Reference
Rmt Vendor Data: 0x12 0x34 0x56 0x78
0x12 0x34 0x56 0x78
View This command can be used in the following views:
■ Any view
Table 1 Description on the fields of the display dsl status command
Field Description
Operating Mode CPE or CO
DSL Mode Annex supported by the interface: Annex A or Annex B
Configured Wire Type Configured wire mode of the interface: two-wire or four-wire
Line A Statistics since
last activation
Statistics about wire-pair A
CRC Count of CRC errors
LOSW Defect Count of loss of synchronization word defects
ES Errored second, count of errors per second
SES Severely errored second, count of severe errors per second
UAS Unavailable second, count of one-second intervals for which the
G.SHDSL line is unavailable
TX EOC Count of transmitted EOC cells
RX EOC Count of received EOC cells
Line A status State of wire-pair A
Xcvr Op State: Data
Mode
Operating state of the receiver
Last Fail Op State Operating state of the receiver when the last negotiation failed
Frame Sync State of frame synchronization
Line Rate(Kbps) Negotiated wire-pair speed
Wire Type Wire type: four-wire, or two-wire
SNR Margin(dB) Margin to SNR
Loop Attenuation(dB) Loop attenuation
RecvGain(dB) Receive gain
TxPower(dBm) Transmit power
Power Backoff State of power compensation
Power Backoff Level Level of power compensation
Tip/Ring Reversal State of Tip/Ring reverse
FrmOH Stat Frame outflow state
Rmt Encoder A Encoding coefficient A
Rmt Encoder B Encoding coefficient B
Rmt NSF Cusdata Remote NSF user data
Rmt NSF CusID Remote NSF user ID
Rmt Country Code Country code
Rmt Provider Code Code of the chip provider
Rmt Vendor Data Code of the chip vendor