Command Reference Guide

3Com Router 5000 Family and Router 6000 Family display dsl status ● 97
Command Reference
display dsl status
Purpose Use the display dsl status command to view state about the specified DSL
interface.
Syntax display dsl status interface atm interface-number
Parameters interface-number
Interface number
Example Display state information of the specified two-wire G.SHDSL interface that is up.
[3Com -Atm3/0/0] display dsl status interface atm 3/0/0
Operating Mode: CPE
DSL Mode: SHDSL Annex B
Configured Wire Type: 2
Line A Statistics since last activation:
Line A Statistics since last activation:
CRC: 0
LOSW Defect: 0
ES: 0
SES: 0
UAS: 0
TX EOC: 0
RX EOC: 0
Line A status:
Xcvr Op State: Data Mode
Last Fail Op State: 0x00
Frame Sync: in sync
Line Rate(Kbps): 2312
Wire Type: 2
SNR Margin(dB): 16.30
Loop Attenuation(dB): 0.00
RecvGain(dB): 6.07
TxPower(dBm): 9.50
Power Backoff: enable
Power Backoff Level: 5
Tip/Ring Reversal: Reversed
FrmOH Stat: 0x00
Rmt Encoder A : 0x0000016e
Rmt Encoder B : 0x00000331
Rmt NSF Cusdata : 0x0000
Rmt NSF CusID : 0x0000
Rmt Country Code : 0x00b5
Rmt Provider Code: GSPN
Rmt Vendor Data: 0x12 0x34 0x56 0x78
0x12 0x34 0x56 0x78
Display state information of the specified four-wire G.SHDSL interface that is up.
[Router-Atm3/0/0]display dsl status interface atm 3/0/0
Operating Mode: CPE
DSL Mode: SHDSL Annex B
Configured Wire Type: 4