Command Reference Guide

3Com Router 5000 Family and Router 6000 Family display dsl configuration ● 93
Command Reference
display dsl configuration
Purpose Use the display dsl configuration command to view the actual DSL
configurations.
Syntax display dsl configuration interface atm interface-number
Parameters interface-number
Interface number
Example Display the actual G.SHDSL configurations.
[3Com -Atm3/0/0]display dsl configuration interface atm 3/0/0
GSHDSL line parameter and mode Configuration
Mode: CPE
Standard: G991.2
Annex: B
Wire Type: 2
Framing: 3
SNR Threshold: 25 dB
Line Rate: Auto Adaptive
Current Margin: 2
SNEXT margin: 0
Target Margin: 3 dB
Psd Mode: Sym PSD
Power-Backoff: Disable
LinkCheck: Disable
--Actual Handshake Status --
00: 0002 0000 0000 0000 0000 0000 0000 0000 0000 0000
10: 0000 0008 0000 0000 0000 0000 0000 0000 0008 0000
20: 0000 0000 0002 0002 0004 0010
--Local Handshake Status --
00: 0002 0001 0000 0000 0000 0000 0034 003f 003f 003f
10: 003f 003f 0003 0034 003f 003f 003f 003f 003f 0003
20: 0000 0000 0003 0003 000f 0010
--Remote Handshake Status --
00: 0002 0000 0000 0000 0000 0000 0030 003f 003f 003f
10: 003f 000f 0000 0030 003f 003f 003f 003f 000f 0000
20: 0000 0000 0003 0003 0004 0010
Table 1 Description on the output of the display dsl configuration command
Field Description
Mode Operating mode, customer premises equipment (CPE) or central
office (CO)
Standard The supported standard
Annex The available options are a and b.
Wire Type Two-wire system or four-wire system.
SNR Threshold Signal to noise ratio threshold
Current Margin Current margin
SNEXT margin Worst-case margin
Target Margin ––
Line Rate ––