Command Reference Guide

3Com Router 5000 Family and Router 6000 Family async mode padpos ● 13
Command Reference
async mode padpos
Purpose Use the async mode padpos command to configure a POSPAD access port.
Use the undo async mode padpos command to remove the POSPAD access port
setting.
Syntax async mode padpos pos-number
undo async mode padpos
Parameters pos-number
Number for the POSPAD access port. Valid values are 0
to 255.
Example Configure Async1/0/0 as POSPAD access port 200.
[Router-Async1/0/0] async mode protocol
[Router-Async1/0/0] async mode padpos 200
View This command can be used in the following views:
■ Asynchronous Serial Interface view
■ AUX Interface view
Description After a POSPAD access port is configured, the access router simulates the POSPAD
device to receive packets from the connected POS terminal and sends them to the
POSPAD concentrator by performing PAD tasks.
Related Commands ■ async mode protocol
■ undo detect dsr-dtr