Command Reference Guide

70 ● detect-ais (CE1/PRI Interface) 3Com Router 5000 Family and Router 6000 Family
Command Reference
detect-ais (CE1/PRI Interface)
Purpose Use the detect-ais command to enable alarm indication signal (AIS) detect on the
CE1/PRI interface.
Use the undo detect-ais command to disable AIS detect on the CE1/PRI
interface.
Syntax detect-ais
undo detect-ais
Parameters None
Default By default, AIS detect is enabled on the CE1/PRI interface.
Example Disable AIS detect on interface E1 3/0/0.
[3Com -E1 3/0/0] undo detect-ais
View This command can be used in the following views:
■ CE1/PRI Interface view
Description Before enabling or disabling AIS detect for a CE1/PRI interface, you must configure
the interface to operate in E1 mode with the using e1 command.