Command Reference Guide

3Com Router 5000 Family and Router 6000 Family accounting commands ● 9
Command Reference
accounting commands
Purpose Use the accounting commands command to enable the system to start
per-command accounting for terminal users logged into the user interface.
Use the undo accounting commands command to stop per-command
accounting for terminal users.
Syntax accounting commands scheme
undo accounting commands scheme
Parameters scheme
Implements per-command accounting using the
scheme specified by the scheme command, which can
only be the terminal access controller access control
system (TACACS) scheme currently.
Default By default, per-command accounting is not configured.
Example Perform per-command accounting on the VTY 0 user interface.
[3Com] user-interface vty 0
[3Com-ui-vty0] accounting commands scheme
View This command can be used in the following views:
■ User Interface view
Description At present, per-command accounting for terminal users is available with the
HWTACACS protocol only.
After this function is enabled on a user interface, a command statistics packet is sent
to a TACACS accounting server for statistics and accounting each time a login
terminal user executes a command.
When the TACACS accounting server becomes unavailable, the terminal user can
execute commands normally but with per-command accounting stopped. The system,
however, does not record or inform the terminal user of this event.