Command Reference Guide

428 ● user privilege 3Com Router 5000 Family and Router 6000 Family
Command Reference
user privilege
Purpose Use the user privilege command to configure the command level that the login
users on the current user interface can access.
Use the undo user privilege command to cancel the current setting.
Syntax user privilege level level
undo user privilege level
Parameters level
Command level. Valid values are 0 to 3.
Default By default, the default command level is three for the console user interface and zero
for other user interfaces.
Example Set the command level that the users logging in from VTY 0 to two.
[3Com-ui-vty0] user privilege level 2
After the user telnets to the router from VTY 0, the terminal displays:
<3Com>
View This command can be used in the following views:
■ User Interface view
Description When a user logs onto the router from a user interface, the command level that the
user can access depends on two points. One is the command level that the user itself
can access, the other is the command level assigned to this user interface. If the two
levels are different, the former is taken. For example, the command level of the VTY 0
user interface is two; however, user 007 has the right to access command level 3. If
007 logs in from VTY 0 user interface, he can access commands at level 3 and lower.