Command Reference Guide

3Com Router 5000 Family and Router 6000 Family user-interface ● 427
Command Reference
user-interface
Purpose Use the user-interface command to enter single-user interface view or
multi-user interface view.
Syntax user-interface [ type-keyword ] number [ ending-number ]
Parameters type-keyword
User interface type.
number
The first user interface to be configured.
ending-number
The last user interface to be configured.
Example Enter the view of the console 0 user interface.
[3Com] user-interface console 0
[3Com-ui-console0]
Enter the view of the VTY 0 user interface.
[3Com] user-interface vty 0
[3Com-ui-vty0]
Enter the view of the user interfaces VTY 0 through VTY 3.
[3Com] user-interface vty 0 3
[3Com-ui-vty0-3]
Enter user interface view to configure user interfaces 0 through 3. The types of the
interfaces include console, AUX and VTY. The actual user interface types however
depend on the interfaces provided by the router. If the router does not provide the
AUX port, this example configures one console user interface and three VTY user
interfaces.
[3Com] user-interface 0 3
[3Com-ui0-3]
View This command can be used in the following views:
■ System view
Description You can specify a user interface view by its relative index or absolute index. In the
former case, you need also to specify the type of the user interface whereas in the
latter case you do not need to do so. For more information on the numbering rules,
refer to the section “Numbering User Interfaces” in the chapter “User Interface
Configuration” of V 2.41 Operation Manual – System Management.