Command Reference Guide

3Com Router 5000 Family and Router 6000 Family telnet-server source-interface ● 389
Command Reference
telnet-server source-interface
Purpose Use the ftp-server source-interface command to specify a source
interface, which must be an existing local interface, for the Telnet server. After that,
the IP address of the specified interface is used as the source IP address in each packet
sent by the Telnet server.
Use the undo ftp-server source-interface command to delete the source
interface specified for the Telnet server. After that, the source IP address in each
packet sent by the Telnet server is that of the outgoing interface where the packet is
sent out.
Syntax telnet-server source-interface interface-type interface-number
undo telnet-server source-interface
Parameters interface-type
interface-number
Specifies an interface by its type and number.
Default By default, the source IP address in each packet sent by the Telnet server is the IP
address of the interface where the packet is sent out.
Example Set the source interface for the Telnet server to ethernet0/0/0.
[Router] telnet-server source-interface Ethernet 0/0/0
View This command can be used in the following views:
■ System view
Description You may specify a source IP address for the packets sent by the Telnet server with the
telnet-server source-interface command or with the telnet-server
source-ip command. If both commands are configured, the one configured later
overrides.