Command Reference Guide

330 ● send-trap 3Com Router 5000 Family and Router 6000 Family
Command Reference
send-trap
Purpose Use the send-trap command to configure the type of events that trigger trap
sending.
Use the undo send-trap command to cancel the configuration of the event type.
Syntax send-trap { all | probefailure | testcomplete | testfailure }
undo send-trap { all | probefailure | testcomplete | testfailure }
Parameters probefailure
Sends traps after test packet transmission fails.
testcomplete
Sends traps upon completion of the test.
testfailure
Sends traps upon test failures.
all
Sends traps for all the events described above.
Default By default, no traps are sent.
Example Send traps upon completion of tests.
[Router-administrator-icmp] send-trap testcomplete
View This command can be used in the following views:
■ HWPing Test Group view