Command Reference Guide

3Com Router 5000 Family and Router 6000 Family display rcrlocal statistics ● 11
Command Reference
display rcrlocal statistics
Purpose Use the display rcrlocal statistics command to display information about
the traffic loads of the interfaces with equal cost routes to all or a specified
destination address.
Syntax display rcrlocal statistics [ ip-address { mask-length | net-mask } ]
Parameters ip-address
IP address of an interface, in dotted decimal notation.
mask-length
Length of the subnet mask, a decimal numeral.
net-mask
Corresponding subnet mask, in dotted decimal
notation.
Example When the load balancing is in RCR mode, display the traffic loads of all the outbound
interfaces with equal cost routes.
[3Com] display rcrlocal statistics
Destination/MaskLen Outgoing Interface Nexthop Traffic
Load(KB/s)
10.1.1.0/24 Ethernet0/0/0 202.1.1.3 501
Serial1/0/0 202.1.2.1 15
11.1.2.0/16 Ethernet0/0/0 202.1.1.3 400
Atm0/0/0 172.31.1.1 610
View This command can be used in the following views:
■ Any view
Description Enter the optional parameter to display the traffic loads of relevant interface to
specified address. If the parameter is not entered, information about the traffic loads
of all equal cost routes are displayed.
Table 2 Description on the fields of the display rcrlocal statistics command
Field Description
Destination/MaskLen Destination address/Mask length
Outgoing Interface Outgoing interface
Nexthop Address of the next hop
Traffic Load(KB/s) Allocated traffic loads of the streams to the same routing
direction on the interface