Command Reference Guide

6 ● debugging rcrlocal event 3Com Router 5000 Family and Router 6000 Family
Command Reference
debugging rcrlocal event
Purpose Use the debugging rcrlocal event command to enable RCR debugging.
Use the undo debugging rcrlocal event command to disable RCR
debugging.
Syntax debugging rcrlocal event
undo debugging rcrlocal event
Parameters None
Default By default, the RCR debugging is disabled.
Example Enable local RCR mode debugging. Suppose that you have enabled local RCR mode,
added the destination addresses, and enabled dynamical adjustment.
3Com> debugging rcrlocal event
*0.46440700 Quidway RCRL/8/RCRL_DEBUG_EVENT:
Check an adjust route node for infomation.
DestIPAddr: 88.1.0.0, Mask : 255.255.0.0.
Check the routes to the current destination address.
*0.46440870 Quidway RCRL/8/RCRL_DEBUG_EVENT:
Total 3 interface available to this IP. PretotalMargin:357248
Idx: 898 Bnd: 10000 CurLoad: 219816 ExpLoad: 123651
Idx: 1026 Bnd: 50000 CurLoad: 439633 ExpLoad: 618256
Idx: 1154 Bnd: 100000 CurLoad: 1318973 ExpLoad: 1236513
If multiple equal cost routes to the current destination address are present, and they
correspond to multiple outbound interfaces (three in this case), the system outputs
the basic information about these interfaces.
*0.46441220 Quidway RCRL/8/RCRL_DEBUG_EVENT:
In Collecting Netstream entries.
Adjust Node mask:255.255.0.0, Adjust Node IP:88.1.0.0
Entry mask:255.255.0.0, Entry IP:88.1.0.4
Filter data streams found during Netstream data stream collection.
*0.46441440 Quidway RCRL/8/RCRL_DEBUG_EVENT:
In Collecting Netstream entries.
Adjust Node mask:255.255.0.0, Adjust Node IP:88.1.0.0
Entry mask:255.255.0.0, Entry IP:88.1.0.3
Filter data streams found during Netstream data stream collection.
*0.46441660 Quidway RCRL/8/RCRL_DEBUG_EVENT:
In Collecting Netstream entries.
Adjust Node mask:255.255.0.0, Adjust Node IP:88.1.0.0