Command Reference Guide

2 ● adjust-interval 3Com Router 5000 Family and Router 6000 Family
Command Reference
adjust-interval
Purpose Use the adjust-interval command to set the time interval for dynamically
adjusting the loads of the interfaces corresponding to the equal cost routes.
Use the undo adjust-interval command to restore the default time interval,
which is 10 seconds.
Syntax adjust-interval seconds
undo adjust-interval
Parameters seconds
Time interval for dynamic adjustment (in seconds).
Valid values are 0 to 600. If the value is set to 0, the
dynamic adjustment is disabled.
Example Set the time interval for dynamic adjustment to 1 minute.
<3Com> system-view
[3Com] rcrlocal
[3Com-rcrlocal] adjust-interval 60
Restore the default time interval for dynamic adjustment.
<3Com> system-view
[3Com] rcrlocal
[3Com-rcrlocal] undo adjust-interval
View This command can be used in the following views:
■ Rcrlocal view
Description Since several times of adjustment may be required for the optimal load ratio, you are
recommended to set a time interval that is not too long when you want to enable the
dynamic adjustment function. Otherwise, disable the dynamic adjustment function.