Command Reference Guide

186 ● x25 map clns 3Com Router 5000 Family and Router 6000 Family
Command Reference
■ roa-list name: Specifies an ROA list name
configured using the x25 roa command in system
view for the X.25 interface.
■ send-delay milliseconds: Specifies to carry
maximum transmission delay requests when
launching calls using this address mapping.
■ threshold in out: Specifies the acceptable
throughput. The value of in/out can be 75, 150,
300, 600, 1200, 2400, 4800, 9600, 19200, and
48000. This option is used when negotiating with
the peer.
■ vc-per-map count: Specifies the maximum number
of virtual circuits permitted to associate with the
address mapping.
■ window-size input-window-size
output-window-size: Specifies the acceptable input
and output window size. The two values range
from 1 (include) to
Example Configure CLNS address mapping on X.25 interface Serial0/0/0.
[3Com ] interface serial 0/0/0
[3Com -Serial0/0/0] x25 map clns x121-address 2
Configure IP and CLNS address mapping on X.25 interface Serial0/0/0.
[3Com ] interface serial 0/0/0
[3Com -Serial0/0/0] x25 map ip 1.1.1.1 clns x121-address 2
View This command can be used in the following views:
■ Interface view
Description No CLNS address mapping is configured by default.
Since X.25 protocol can multiplex multiple logical virtual circuits on a physical
interface, you need to manually specify the mapping between network addresses and
X.121 addresses.
You can configure only one X.25 CLNS mapping on a point-to-multipoint X.25
interface. You need to remove the existing X.25 CLNS mapping first if you want to
configure another mapping on the same interface.
You cannot modify any parameters (including protocol address, X.121 address and all
options) of a configured address mapping. As an alternative, you can delete the
address mapping using the undo x25 map command, and then establish a new
one.
Protocol addresses of address mappings configured for the same X.25 interface
cannot be the same.