Command Reference Guide

3Com Router 5000 Family and Router 6000 Family x25 map clns ● 185
Command Reference
x25 map clns
Purpose Use the x25 map clns command to configure a CLNS address mapping for an
X.121 address.
Use the undo x25 map command to remove an existing mapping.
Syntax x25 map clns x121-address x.121-address [ option ]
undo x25 map clns
Parameters clns
Specifies to use CLNS protocol.
protocol-address
Protocol address of the peer ES.
x.121-address
X.121 address of the peer ES.
option
Attributes or user facilities specific to the address
mapping.
The options for the option argument are described
as follows.
■ broadcast: Specifies to send internet protocol
broadcast packets and IP-based multicast packets
to the destination. This option provides solid
support for routing protocols such as Routing
Information Protocol (RIP).
■ closed-user-group group-number: Specifies the
number of the closed user group corresponding to
the address mapping.
■ idle-timer minutes: Specifies the maximum idle time
of the virtual circuit associated with the address
mapping. Value of 0 stands for an infinite idle time.
■ no-callin: Rejects any call for the address mapping.
■ no-callout: Disables calls launched using the
address mapping.
■ packet-size input-packet output-packet: Specifies
the maximum acceptable packet size in bytes for
input and output packets. The two parameters
range from 16 to 4096 (include) and must be the
integer power of 2. This option is used when
negotiating with the peer.
■ reverse-charge-accept: Specifies to accept calls that
contain reverse charge requests. Calls of this type
are only accepted if you specify this option.
■ reverse-charge-request: Specifies to carry reverse
charge requests when launching calls using this
address mapping.