Command Reference Guide

3Com Router 5000 Family and Router 6000 Family sdlc sap-map remote ● 173
Command Reference
sdlc sap-map remote
Purpose Use the sdlc sap-map remote command to configure the remote DLSw device
SAP address when SDLC is translated into LLC2.
Use the undo sdlc sap-map remote command to restore the default value.
Syntax sdlc sap-map remote dsap sdlc-addr
undo sdlc sap-map remote dsap sdlc-addr
Parameters dsap
The SAP address of the DLSw peer device.
By default, dsap is 04.
sdlc-addr
The SDLC address.
Example Configure the remote DLSw device SAP address when SDLC is translated into LLC2.
[3Com -Serial1/0/0] sdlc sap-map remote 0C 05
View This command can be used in the following views:
■ Synchronous Serial Interface view
Description When the SDLC packet is translated into the LLC2 packet, the SAP address is needed
besides the MAC address.
Generally speaking, the SAP address of the SNA protocol is 0x04 or 0x08 or 0x0C.
Related Command sdlc sap-map local