Command Reference Guide

172 ● sdlc sap-map local 3Com Router 5000 Family and Router 6000 Family
Command Reference
sdlc sap-map local
Purpose Use the sdlc sap-map local command to configure the SAP address on
transforming the SDLC into the LLC2.
Use the undo sdlc sap-map local command to restore the default value of the
LLC2 SAP address.
Syntax sdlc sap-map local lsap sdlc-addr
undo sdlc sap-map local lsap sdlc-addr
Parameters lsap
The virtual SAP address set by the device connected
with the local interface.
sdlc-addr
The SDLC address.
Default By default, lsap is 04.
Example Configure the SAP address on translating the SDLC into the LLC2.
[3Com -Serial1/0/0] sdlc sap-map local 08 05
View This command can be used in the following views:
■ Synchronous Serial Interface view
Description When the SDLC packet is translated into the LLC2 packet, the SAP address is needed
besides the MAC address.
Generally speaking, the SAP address of the SNA protocol is 0x04 or 0x08 or 0x0C.
For related configuration, please see the sdlc sap-map remote command.