Command Reference Guide

3Com Router 5000 Family and Router 6000 Family sdlc mac-map remote ● 167
Command Reference
sdlc mac-map remote
Purpose Use the sdlc mac-map remote command to configure the SDLC peer.
Use the undo sdlc mac-map remote command to delete the SDLC peer.
Syntax sdlc mac-map remote mac-addr sdlc-addr
undo sdlc mac-map remote mac-addr sdlc-addr
Parameters mac-addr
The MAC address of the SDLC peer.
sdlc-addr
The SDLC address of the SDLC peer.
Default By default, the synchronous serial interface has no peer.
Example Configure the SDLC peer.
[3Com -Serial1/0/0] sdlc mac-map remote 00E0-FC00-0010 0x05
View This command can be used in the following views:
■ Synchronous Serial Interface view
Description This command is used to specify the MAC address of a peer end for an SDLC virtual
circuit so as to provide the destination MAC address on the transformation from the
SDLC to the LLC2. When configuring the DLSw, an SDLC address should be
configured a related partner (peer). The MAC address of the partner (peer) should be
the MAC address of the remote SNA device (physical addresses of such devices as the
Ethernet and the Token-Ring), or the MAC address of the peer end compounded by
the SDLC.