Command Reference Guide

3Com Router 5000 Family and Router 6000 Family dlsw remote ● 105
Command Reference
dlsw remote
Purpose Use the dlsw remote command to create the DLSw remote peer.
Use the undo dlsw remote command to delete the remote peer.
Syntax dlsw remote ip-address [ acl acl-number | backup backup-address |
priority priority | keepalive keepalive-interval | max-frame
max-frame-size | max-queue max-queue-length | linger minutes ] *
undo dlsw remote ip-address
Parameters ip-address
Specifies the IP address of the remote peer.
acl acl-number
Number of ACL, ranging from 4000 to 4999.
backup backup-address
Backup IP address of the remote peer.
priority priority
Transmission priority. Valid values are 1 to 5.
If not specified, the default transmission priority is 3.
keepalive
keepalive-interval
Time interval for sending the “keepalive” packet (in
seconds). Valid values are 0 to 1200.
If not specified, the default keepalive interval is 30
seconds.
max-frame max-frame-size
Maximum length of packets, which can be 516, 1470,
1500, 2052, 4472, 8144, 11,407, 11,454, or 17,800
bytes.
If not specified, the default maximum length of
packets is 1500 bytes.
max-queue max-queue-length
Size of the TCP sending/receiving queue. Valid values
are 50 to 2000.
If not specified, the default maximum queue length is
200.
linger minutes
Linger time of the backup connection after the primary
peer being disconnected (in minutes). Valid values are
0 to 1440.
If not specified, the default linger time is 5 minutes.
Example Create the DLSw remote peer, with the IP address being 2.2.2.2, the transmission cost
being 2, the time interval for sending the “keepalive” being 40 seconds, the
maximum length lf-size of the packet being the default value, and the size of the TCP
sending/receiving queue being 300.
[3Com ] dlsw remote 2.2.2.2 priority 2 keepalive 40 max-queue 300
View This command can be used in the following views:
■ System view