Command Reference Guide

102 ● dlsw remote 3Com Router 5000 Family and Router 6000 Family
Command Reference
dlsw remote
Purpose Use the dlsw remote command to create a remote DLSw peer and specifies its
version and filtering rule.
Use the
undo dlsw remote command to remove a remote DLSw peer.
Syntax dlsw remote ip-address [ version version-number | acl acl-num ] *
undo dlsw remote ip-address
Parameters ip-address
Specifies the IP address of a remote peer.
version version-number
Sets the DLSw version of the remote peer to 1 or 2.
The default DLSw version is 1.
acl acl-num
Specifies the ACL for filtering packets from the peers.
The ACL number must be in the range 4000 to 4999.
Example Create a DLSw remote peer 192.168.100.10 and sets its DLSw version to 2.0.
[3Com ] dlsw remote 192.168.100.10 version 2
Specify to filter packets from peer 1.1.1.1 using ACL 4000. That is, for packets from
1.1.1.1, permit only packets with a MAC address of 3-2-3 to pass through.
[3Com ] acl number 4000
[3Com -acl-ethernetframe-4000] rule 3 permit source-mac 0003-0002-0003
ffff-ffff-ffff
[3Com -acl-ethernetframe-4000] quit
[3Com ] dlsw remote 1.1.1.1 acl 4000
View This command can be used in the following views:
■ System view
Description You can find the description on the other keywords of the commands in the
description on the
dlsw remote command in DLSw1.0.