Command Reference Guide

3Com Router 5000 Family and Router 6000 Family pos-server app tcp ● 263
Command Reference
pos-server app tcp
Purpose Use the pos-server app tcp command to configure a POS application in TCP/IP
connection mode.
Use the undo pos-server app tcp command to remove the specified POS
application.
Syntax pos-server app tcp app-number ip-address port-number
undo pos-server app tcp app-number
Parameters app-number
Number for the POS application. Valid values are 0 to
31. A router can be configured with up to 32 POS
applications.
ip-address
Destination address of the POS application in TCP/IP
connection mode.
port-number
Port number of the POS application in TCP/IP
connection mode. Valid values are 1 to 65,535.
Default By default, no POS application is configured.
Example Configure POS application 1 with IP address 1.1.254.78 and port number 9010.
[Router] pos-server app tcp 1 1.1.254.78 9010
View This command can be used in the following views:
■ System view
Description A POS access router can be connected to a UNIX FEP in one of two ways:
asynchronous and TCP/IP. When configuring a POS application in asynchronous
connection mode, a different command is used.
On a TCP/IP connection, an application is identified by IP address and port number.
Two applications are regarded unique, whether they use different IP addresses or use
the same IP address but different port numbers.