Command Reference Guide

3Com Router 5000 Family and Router 6000 Family display x25 map ● 87
Command Reference
display x25 map
Purpose Use the display x25 map command to display X.25 address map information.
Syntax display x25 map
Parameters None
Example Display X.25 address map information.
[3Com ] display x25 map
Interface:Serial3/0/0(protocol status is up):
ip address:202.38.162.2 X.121 address: 22
map-type: SVC_MAP VC-number: 0
Facility:
ACCEPT_REVERSE;
BROADCAST;
PACKET_SIZE: I 512 O 512 ;
Interface:Serial1/0/0.1(protocol status is up):
Clns enabled X.121 address: 30
map-type: PVC_MAP VC-number: 0
Facility:
PACKET_SIZE: I 512 O 512 ;
Table 1-3 describes the above output information.
View This command can be used in the following views:
■ Any view
Description X.25 address map can be configured by using the x25 map command or the x25
pvc
command. The display x25 map command can be used to show all X.25
address mappings
Table 29 Description on the fields of the display x25 map command
Field Description
Interface:Serial3/0/0(protocol status is up): The mapped interface and its state
ip address:202.38.162.2 X.121 address: 22 The IP address and corresponding X.121 address
of the interface
map-type: SVC_MAP The map type is SVC_MAP
VC-number: 0 Number of the virtual circuits
Facility:
ACCEPT_REVERSE;
BROADCAST;
PACKET_SIZE: I 512 O 512 ;
Clns enabled CLNS is enabled