Command Reference Guide

3Com Router 5000 Family and Router 6000 Family display ipx interface ● 75
Command Reference
display ipx interface
Purpose Use the display ipx interface command to view IPX interface configuration
information and interface parameters in communication devices.
Syntax display ipx interface [ interface-type interface-num ]
Parameters interface-type
Interface type.
interface-num
Interface number.
Example Display IPX configuration and statistics of the interface Ethernet1/0/0.
<3Com > display ipx interface ethernet 1/0/0
Ethernet1/0/0 is up
IPX address is 2.00E0-FC01-0000 [up]
SAP is enabled
Split horizon is enabled
Update change only is disabled
Forwarding of IPX type 20 propagation packet is enabled
Delay of this IPX interface, in ticks is 1
SAP GNS response is enabled
RIP packet maximum size is 432 bytes
SAP packet maximum size is 480 bytes
IPX encapsulation is Netware 802.3
0 received, 0 sent
0 bytes received, 0 bytes sent
0 RIP received, 0 RIP sent, 0 RIP discarded
0 RIP specific requests received, 0 RIP specific responses sent
0 RIP general requests received, 0 RIP general responses sent
0 SAP received, 0 SAP sent, 0 SAP discarded
0 SAP requests received, 0 SAP responses sent
Table 24 Description of display information of the display ipx interface command
Field Description
Ethernet1/0/0 is ... In terms of physical layer and link layer status, the current interface
is UP, DOWN or administratively DOWN.
IPX address is ... IPX network ID and node value of the current interface. Refer to the
commands ipx network and ipx enable for details of network ID and
node value.
[up] IPX protocol status of the current interface.
SAP is … Whether SAP is enabled on the current interface.
Split horizon is … Whether split horizon is enabled on the current interface. The
related command is ipx split-horizon.
Update change only is
…
Whether trigger update is enabled on the current interface. The
related command is ipx update-change-only.
Forwarding of IPX type
20 propagation packet
is ...
Whether IPX type 20 propagation packet is permitted to be
forwarded on the current interface. The related command is ipx
netbios-propagation.
Delay of this IPX
interface, in ticks is ...
Delay value of the current interface. The value is configured by the
ipx tick command.