Command Reference Guide

70 ● display fr map-info 3Com Router 5000 Family and Router 6000 Family
Command Reference
display fr map-info
Purpose Use the display fr map-info command to display frame relay (FR) address map
information.
Syntax display fr map-info [ interface interface-type interface-num ]
Parameters interface-type
interface-num
Specifies the interface to be displayed. You can specify
an interface or a sub-interface. If you do not specify an
interface, information about all interfaces is displayed.
Example Display FR address map information.
<3Com > display fr map-info
Map Statistics for interface Serial1/0/2 (DTE)
DLCI = 100, CLNS, Serial1/0/2
create time = 2002/10/21 14:48:44, status = ACTIVE
encapsulation = ietf, vlink = 14
View This command can be used in the following views:
■ Any view
Description You can use this command to check to see if static address maps are correctly
configured and dynamic address maps operate properly.
Table 21 Description on the fields of the display fr map-info command
Field Description
A message that prompts you whose information is displayed
DLCI = 100, CLNS,
Serial1/0/2
create time = 2002/10/21
14:48:44
The time the map is created
encapsulation = ietf The encapsulation format is IETF.