Command Reference Guide

3Com Router 5000 Family and Router 6000 Family display atm map-info ● 49
Command Reference
display atm map-info
Purpose Use the display atm map-info command to display upper layer protocol map
information about a specified ATM interface.
Syntax display atm map-info [ interface { interface-name | interface-type
interface-num } [ pvc { pvc-name | vpi/vci } ] ]
Parameters interface-name
Name of the ATM interface. Provide this argument in
this form:
interface-name = interface-type
interface-num
interface-type
Interface type.
interface-num
Interface number.
pvc-name
Name of the permanent virtual circuit (PVC). This
argument is not case-sensitive and can be up to 16
characters in length. For an ATM interface, the name
of a PVC must be unique and cannot be a valid VPI/VCI
pair. For example, The VPI/VCI pair 1/20 cannot be the
name of a PVC. (VPI: virtual path identifier, VCI: virtual
channel identifier)
vpi/vci
VPI/VCI pair. Valid values for the VPI are 0 to 255. The
available range of VCI depends on interface type and is
listed in Error! Reference source not found.. Do not
specify a VCI value within a range of 0 to 31, which is
reserved for special use.
Example Display upper layer protocol map information about all ATM interfaces of the device.
<3Com > display atm map-info
Atm1/0/0.1, PVC 1/33, CLNS, State UP
View This command can be used in the following views:
■ Any view
Table 9 VCI range of an ATM interface
Interface type VCI range
ADSL 0 to 255
GSHDSL 0 to 255
ATMOC3 0 to 1023
ATM25 0 to 511
ATME3 0 to 1023
ATMT3 0 to 1023
IMA-E1/T1 0 to 511