Command Reference Guide

46 ● debugging esis 3Com Router 5000 Family and Router 6000 Family
Command Reference
debugging esis
Purpose Use the debugging esis event command to enable debugging for ES-IS
protocol-related events. You can display event information using this command, such
as changes of neighbor states, entries in Level 0 routing table, and interface states.
Use the undo debugging esis event command to disable debugging for ES-IS
protocol-related events.
Use the debugging esis packet command to enable debugging for ES-IS
packets. You display information about received/transmitted ES-IS packets, such as
packet size, packet type, packet HT, and Layer 2 and Layer 3 address.
Use the undo debugging esis packet command to disable debugging for
ES-IS packets.
Syntax debugging esis { event | packet }
undo debugging esis { event | packet }
Parameters None
Example Enable debugging for ES-IS protocol-related events.
<3Com > debugging esis event
View This command can be used in the following views:
■ User view