Command Reference Guide

38 ● debugging ipx rip 3Com Router 5000 Family and Router 6000 Family
Command Reference
debugging ipx rip
Purpose Use the debugging ipx rip command to enable RIP debugging switch to view
information on RIP packet received and transmitted, routing changes and timer expiry.
Use the undo debugging ipx rip command to disable RIP debugging switch.
Syntax debugging ipx rip { packet [ verbose ] | event }
undo debugging ipx rip { packet [ verbose ] | event }
Parameters packet
Debugging information of packet received and
transmitted.
verbose
Displays detailed information about packet received
and transmitted.
event
Event debugging information, such as Up/Down of an
interface and related timer events.
Default By default, IPX RIP debugging switch is disabled.
Example Enable IPX RIP packet debugging switch.
<3Com > debugging ipx rip packet
Send RIP Response to Ethernet0/0, length 96
src:a.00e0-fc01-5517(453), dst:a.ffff-ffff-ffff(453)
Number of Entries in Pkt: 8
Enable IPX RIP packet verbose debugging switch.
<3Com > debugging ipx rip packet verbose
Send RIP Response to Ethernet0/0, length 96
src:a.00e0-fc01-5517(453), dst:a.ffff-ffff-ffff(453)
Number of Entries in Pkt: 8
Network 0x1, hops 2, delay 2
Network 0x2, hops 2, delay 2
Network 0x3, hops 2, delay 2
Network 0x4, hops 2, delay 2
Network 0x5, hops 2, delay 2
Network 0x6, hops 2, delay 2
Network 0x8, hops 2, delay 8
Network 0xa, hops 1, delay 2
Enable IPX RIP event debugging switch.
<3Com > debugging ipx rip event
*0.274181351-IPXRIP-8-IPXRIP_Event:
The number 1 equal route nexthop: 00e0-fc04-8859
*0.274181450-IPXRIP-8-IPXRIP_Event:
The network 8 totally have 1 equal route