Command Reference Guide

3Com Router 5000 Family and Router 6000 Family debugging ipx rtpro-interface ● 35
Command Reference
debugging ipx rtpro-interface
Purpose Use the debugging ipx rtpro-interface command to turn on the debugging
switch of interface change in the IPXRM module.
Use the undo debugging ipx rtpro-interface command to turn off the
debugging switch of interface change in the IPXRM module.
Syntax debugging ipx rtpro-interface
undo debugging ipx rtpro-interface
Parameters None
Example Enable IPX RIP packet debugging switch
<3Com > debugging ipx rip packet
Switch on interface change debugging for IPXRM module.
<3Com >debugging ipx rtpro-interface
<3Com >
Trigger interface change by using shut/undo shut command.
[3Com -Serial1] shut
[3Com -Serial1]
%Oct 24 14:11:27 2003 3Com PHY/2/PHY: Serial1: change status to down
%Oct 24 14:11:27 2003 3Com IFNET/5/UPDOWN:Line protocol on the
interface Seri
al1 turns into DOWN state
%Oct 24 14:11:27 2003 3Com IFNET/5/UPDOWN:Protocol IPX on the
interface Seria
l1 turns into DOWN state
*0.19023320 3Com RMX/8/DBG:
IPXRM recieve interface change msg, msg type IPX_IF_DOWN .
if_index is 0x286 .
Interface name is Serial1 .
[3Com -Serial1]
[3Com -Serial1]undo shut
[3Com -Serial1]
%Oct 24 14:11:34 2003 3Com PHY/2/PHY: Serial1: change status to up
%Oct 24 14:11:34 2003 3Com IFNET/5/UPDOWN:Line protocol on the
interface Seri
al1 turns into UP state
%Oct 24 14:11:34 2003 3Com IFNET/5/UPDOWN:Protocol IPX on the
interface Seria
l1 turns into UP state
*0.19032220 3Com RMX/8/DBG:
IPXRM recieve interface change msg, msg type IPX_IF_UP .