Command Reference Guide

3Com Router 5000 Family and Router 6000 Family pad-mode pos enable ● 255
Command Reference
pad-mode pos enable
Purpose Use the pad-mode pos enable command to enable POSPAD access mode.
Use the undo pad-mode pos enable command to restore the default PAD access
mode, that is, X.25 PAD.
Syntax pad-mode pos enable
undo pad-mode pos enable [ posid number ]
Parameters posid number
ID of a POS connection. Valid values are 0 to 255. This
argument is intended for debugging only. You can
view it by executing the display pos-interface
command.
Example Enable POSPAD access mode on interface Serial 1/0/0.
[Router-serial1/0/0] pad-mode pos enable
View This command can be used in the following views:
■ Synchronous Serial Interface view
Description The 3Com Series Routers support two PAD access modes: X.25 PAD and POSPAD.