Command Reference Guide

3Com Router 5000 Family and Router 6000 Family bridge set (in synchronous serial interface view) ● 5
Command Reference
bridge set (in synchronous serial interface
view)
Purpose Use the bridge-set (in Synchronous serial interface system
view)
command to add the synchronous serial interface encapsulated into SDLC
into the bridge group.
Use the undo bridge-set (in synchronous serial interface view)
command to delete the interface from the DLSw bridge group.
Syntax bridge-set bridge-set-number
undo bridge-set bridge-set-number
Parameters bridge-set-number
The bridge group number the synchronous serial port
is to be added into. Valid values are 1 to 63.
Default By default, no synchronous serial port is added into the bridge group.
Example Add the Serial1/0/0 into the DLSw bridge group numbered 20.
[3Com ] dlsw bridge-group 20
[3Com ] interface Serial1/0/0
[3Com -Serial1/0/0] bridge-set 20
View This command can be used in the following views:
■ Synchronous Serial Interface view
Description In order for the SDLC encapsulated synchronous serial port to join the DLSw
forwarding, the SDLC interface is needed to added into a bridge group by using this
command. What is different is that the bridge group on the Ethernet interface joins
the local forwarding, while the bridge group configured on the SDLC only joins the
DLSw forwarding, that is, all the data on it will be forwarded onto the TCP tunnel. If it
is configured in the Ethernet Interface view, the Ethernet interface of the same group
number on the router can forward packets transparently. But packets cannot be
transferred transparently between the serial ports. Each serial port only exchanges
packet with the remote end.